Solitvde 1.4 opens up two more destinations in the modulation matrix.

Features:
- Filter Q and Mix can now be modulation targets. These were both asked for in an App Store review. Thank you, it was a good idea.

Fixes:
- On macOS, popover corners now match the panel they sit in.
- Slight UI performance improvements.

Solitvde 1.3 is a big feature update.

New:
- Adds a new Reverse shimmer mode. The shimmer voices read their grains backwards, smearing transients and transforming the texture of the tail.
- Exposes a grain control for transforming the period of the shimmer voices.
- Exposes two modulation-only parameters in the Motion section - Warp & Ensemble.
- The envelope follower gained an onset Delay and tempo-sync. Its Release and Delay can lock to note divisions, so the follower breathes in time with the host.
- Side-chain input. Add a second input, so an external signal can drive the modulation in supported hosts.
- A new Level fader replaces the separate swell and output gains. Put it before the tank for reverse-style swells, or after it for ducking or tremolo.
- A fresh set of factory presets, plus five that show off the new features directly: reverse, long grains, side-chain ducking, synced swells, and warp with ensemble drift.

Improvements:
- Deeper Warp (±12.5 ms) and Ensemble (12 ms) modulation.
- Retuned the envelope Attack and Sensitivity ranges onto log tapers.

Fixes:
- Fixed a click when Size sat at 0%. The fader now floors at 1%.
- The manual button opened an unrelated app on some iOS layouts. It now opens the manual inside the plugin everywhere.

Solitvde 1.2 is a small stability and polish update.

Fixes:
- Fixed a rare crash when loading Solitvde in some hosts. Certain audio buffer sizes, common when routing through Bluetooth output, could crash it as it started rendering.
- Fixed occasional clicks from the Warp modulation at larger audio buffer sizes.

Improvements:
- Smoother transitions when switching between modulation sources in the source view.
- Removed the last memory allocations from the audio render thread, one less source of dropouts under load.

Solitvde 1.1 comes with some new features and fixes a few core issues.

Features:
- There's now the ability to change filter placement. It can be re-routed from the default, post-tank to either before the tank, or inside the tank's feedback loop.
- The in-loop filter has some subtle character, a low-pass darkens the tail, a high-pass thins it, and a band-pass focuses it as it recirculates.
- Freeze now holds the tail cleanly at any amount, and the middle of the fader is a long, playable sustain instead of only holding near the top.

Fixes:
- Dragging or modulating Size, Density, Width, and Damping now applies at sample rate, so fast modulation stays impeccably clean.
- Fixed some cases of resonant filters exploding the tank.
- Fixed an issue where small freeze and shimmer combinations accumulated too much low-end.